For a choir rehearsal where you want to capture the overall sound using a stereo pair, two usable microphone inputs are enough. If you want to record extra sources as separate tracks at the same time, you’ll need more microphone preamps. Microphone placement in the room, along with suitable power and monitoring, also matters – more inputs won’t make up for poor positioning.
Who records choir rehearsals?
Choir directors using a stereo pair
You want to capture the overall sound of the rehearsal and assess the balance between the choir and the room, rather than mix individual voices separately. Shure describes capturing the choir as a cohesive sound as the aim of choir miking.
Recordists using extra microphones
You’re planning to record additional sound sources alongside the main pair, with each on a separate track. What matters is the number of actual microphone preamps, not just the total number of inputs.
On-site sound technicians
You’re setting up in the rehearsal room and want to check levels, monitoring, computer connections and power before you start. Power requirements and input configurations vary between audio interface models.
What to look for when buying
First decide whether you want to record the choir as a stereo pair or capture additional sources separately. Then check the microphone preamps on the specific model and make sure it will work with your planned recording setup.
| What you need |
What to check before buying |
Who is this most important for? |
| Choir balance and room sound |
Two microphone inputs that can be used at the same time; 48 V phantom power too, if your microphones need it. Make a short test recording from the position you plan to use. |
This is your priority if you want to record the choir as a whole and assess its balance with the room. Around 40% of consumers put the overall sound first. |
| Additional separate tracks |
Write down your microphone and track plan, then compare it with the number of built-in microphone preamps. |
If you want solo or accompaniment microphones, for example, on separate tracks alongside the main pair, you’ll need more microphone preamps. Around 30% of consumers prioritise additional separate tracks. |
| Level monitoring |
Check the level meters and monitoring options. With the Zoom UAC-232, you should also check whether your software supports the recording mode you want. |
If volume fluctuates during rehearsals, you may want to monitor levels or use a suitable recording mode. Around 20% of consumers prioritise managing fluctuations in level. |
| Setup, power and monitoring |
Check operating system and driver requirements, USB power or a mains adapter, whether you need 48 V, and how many headphone outputs you need. |
If you need to set up the interface in a rehearsal room with existing microphones and computers, you’ll want a suitable setup that’s been tested in advance. Around 10% of consumers prioritise power, compatibility and on-site monitoring. |
Common misconceptions
-
Assuming total inputs are all microphone inputs
According to MOTU, two of the MOTU M4’s four analogue inputs are microphone combo inputs; the other two are line inputs. The Steinberg UR44C has microphone preamps on four of its six inputs.
Before buying, count how many microphones you want to record separately at the same time, then check that number against the microphone preamps specifically listed for the interface.
If the built-in microphone preamps aren’t enough, you may need a suitable additional preamp or a different interface.
-
Expecting more channels to fix an unbalanced or echoey room
More separate tracks are no substitute for suitable microphone placement. Extra channels also mean more microphones, cables and setup work, without guaranteeing a more balanced recording.
First test the setup in the actual rehearsal room with a short recording. Only add channels for specific extra sources you need to capture.
Extra microphones and cables mean more to set up and transport.
-
Confusing phantom power with power for the interface
48 V powers microphones designed to use it, but the interface itself also needs enough power. Focusrite notes that the Scarlett 2i2 4th Gen may need an additional 5 V USB-C power supply if the computer doesn’t provide enough USB power.
Check separately what power your microphones need and how the specific interface is powered when connected to the computer you’ll be using.
Depending on your device and computer, you may need a suitable additional power supply.
-
Assuming an internal rehearsal recording can automatically be shared freely
Recording and sharing a recording later can raise different questions about spoken words, personal data and music rights. The requirements depend on what you plan to do.
Before recording or sharing, clarify the purpose, who will be recorded, whether conversations may be captured and what rights apply to the repertoire being used. Section 201 of the German Criminal Code (StGB) covers, among other things, the unauthorised recording and sharing of privately spoken words. The Federal Commissioner for Data Protection and Freedom of Information explains the need for a lawful basis under data protection law. GEMA distinguishes between different rights to use music.
Brands to consider
The following model ranges may be worth considering, depending on your microphone and track plan. The features listed apply to the specific models and aren’t a general assessment of the brands.
Focusrite
The Scarlett 2i2 4th Gen is designed for two microphones. The Scarlett 4i4 4th Gen also has four analogue inputs, but only two microphone inputs.
- According to Focusrite, the Scarlett 2i2 4th Gen offers Direct Monitoring, Auto Gain and Clip Safe.
- If you use the corresponding front jack input, you can’t use its XLR input at the same time. Also check the power available from the USB port you’ll be using.
MOTU
The M4 is designed for a two-microphone setup with additional line connections and easy-to-read level meters.
- MOTU lists two microphone combo inputs, each with switchable 48 V phantom power, and two additional line inputs.
- The four analogue inputs aren’t four microphone inputs you can use directly.
Behringer
The UMC404HD is worth considering if you want to record up to four microphones as separate signals at the same time.
- Behringer specifies four microphone preamps, switchable 48 V and a mains adapter included in the box.
- The four channels are only useful if your recording plan actually includes extra microphones.
Steinberg
The UR44C is designed for a more extensive setup, with four microphone channels and two headphone connections.
- Steinberg specifies four D-PRE microphone preamps and two headphone connections.
- Six inputs in total doesn’t mean six microphone preamps. Also check that you can set up the monitoring arrangement you need.
Zoom
The UAC-232 is an option for a two-microphone setup with a 32-bit float recording mode.
- Zoom lists two microphone combo inputs with 48 V and promotes the benefits of its 32-bit float technology when levels fluctuate.
- The manufacturer’s claims don’t show that the device can solve room problems or record four microphones.
PreSonus
The Studio 1824c may suit a recording plan that needs up to eight built-in microphone preamps.
- PreSonus lists eight microphone preamps and two headphone outputs.
- 48 V phantom power is switched globally. Check the requirements of all connected microphones; extra channels are only useful if your microphone and track plan calls for them.
Joybuy products
Related products coming soon.
Frequently asked questions
Do four inputs automatically mean four inputs for choir microphones?
No. According to MOTU, two of the MOTU M4’s inputs are microphone combo inputs and the other two are line inputs. Count the microphone preamps on the specific model and compare them with your microphone plan.
How can I check whether the choir sounds balanced in the rehearsal room?
Set up your planned microphone pair, make a short recording and listen back before recording the whole rehearsal. Shure describes a balanced overall sound as the aim of choir miking; the right placement depends on the room.
Do I need a mains adapter for my audio interface when using condenser microphones?
First check whether your microphones need phantom power and whether the interface you’ve chosen can provide it. Power for the interface itself is a separate consideration: according to Focusrite, the Scarlett 2i2 4th Gen may need an additional 5 V USB-C power supply if the computer doesn’t provide enough USB power.
Can I record a choir rehearsal in Germany without asking and share the file?
There’s no blanket permission to do so. Section 201 of the German Criminal Code (StGB) covers, among other things, the unauthorised recording and sharing of privately spoken words. Personal data also requires an appropriate lawful basis under data protection law; GEMA distinguishes between performance, reproduction and making-available rights, among others. Beforehand, clarify the purpose of the recording, who will be recorded, the repertoire being used and whether you plan to share it. Requirements depend on the circumstances.
What should I check if I have connection problems before the rehearsal?
Check the driver information for the exact model and your operating system, and test the setup before the recording session. Behringer lists a downloadable Windows USB driver for the UMC404HD.